IBM DJSA-210 Hard Drive Specifications - Page 77
Deviations from standard, The interface conforms to the Working Document of Information Technology
View all IBM DJSA-210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
9.0 Deviations from standard The device conforms to the referenced specifications, with deviations described below. The interface conforms to the Working Document of Information Technology, AT Attachment with Packet Interface Extension (ATA/ATAPI-5) Revision 2 dated December 13, 1999, with deviation as follows: Standby Timer Write Verify Standby timer is enabled by STANDBY command or IDLE command. The value in the Sector Count register shall be used to determine the time programmed into the Standby timer. If the Sector Count register is zero then the Standby timer is set to 109 minutes automatically. WRITE VERIFY command does not include read verification after write operation. The function is the same as WRITE SECTORS command. S.M.A.R.T. Return Status S.M.A.R.T. RETURN STATUS subcommand does not check advisory attributes. This means that the device will not report a threshold exceeded condition unless the prefailure attributes exceed their corresponding thresholds. For example, a Power-On Hours Attribute never results in a negative reliability status. Travelstar 32GH/30GT/20GN hard disk drive specifications 63