IBM DJSA-210 Hard Drive Specifications - Page 167
Set Features EFh
View all IBM DJSA-210 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
13.28 Set Features (EFh) Command Block Output Registers Register 7 6 5 4 3 2 1 0 Data Feature V V V V V V V V Sector Count Note 1. Sector Number Cylinder Low Cylinder High Device/Head 1 - 1 D - - - - Command 1 1 1 0 1 1 1 1 Command Block Input Registers Register 7 6 5 4 3 2 1 0 Data Error see below Sector Count Sector Number Cylinder Low Cylinder High Device/Head Status see below Error Register 76543210 CRC UNC 0 IDN 0 ABT T0N AMN 00000V00 Status Register 7 6 5 4 3 2 10 BSY RDY DF DSC DRQ COR IDX ERR 0 V 0 - - 0 -V Figure 105. Set Features command (EFh) The Set Feature command establishes the following parameters which affect the execution of certain features as shown in the table below. ABT will be set to 1 in the Error Register if the Feature register contains any undefined values. After the power on reset or hard reset the device is set to the following features as default. Write cache ECC bytes Read look-ahead Reverting to power on defaults Address Offset mode : Enable : 4 bytes : Enable : Disable : Disable Travelstar 32GH/30GT/20GN hard disk drive specifications 153