IC Realtime HDVR-MX0402-1U5MP-AI2-WEB Product Manual - Page 129
Main Menu > Advanced Settings > Network > Email
View all IC Realtime HDVR-MX0402-1U5MP-AI2-WEB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Parameter Alarm-out Port Post-Alarm Show Message Report Alarm Send Email Record Channel PTZ Linkage Post Record Tour Picture Storage Sub Screen Description Click Setting to display the setting interface. ● General Alarm: Enable alarm activation through the alarm devices connected to the selected output port. Set a length of time for the Device to delay turning off alarm after the external alarm has ended. The value ranges from 0 seconds to 300 seconds, and the default value is 10 seconds. If you enter 0, there will be no delay. Select the Show Message check box to enable a pop-up message in your local host PC. Select the Report Alarm check box to enable the system to upload the alarm signal to the network (including alarm center) when an alarm event occurs. Select the Send Email check box to enable the system to send an email notification when an alarm event occurs. To use this function, make sure the email function is enabled in Main Menu > Advanced Settings > Network > Email. Select the channel(s) that you want to record. The selected channel(s) will record when the event has been triggered. The recording for motion detection and auto recording function must be enabled. Click Setting to display the PTZ interface. Enable PTZ linkage actions, such as selecting the preset that you want to be called when an alarm event occurs. Motion Detect can only activate PTZ presets. Set a length of time for the Device to delay turning off recording after the event has ended. The value ranges from 10 seconds to 300 seconds, and the default value is 10 seconds. Select the Tour check box to enable a tour of the selected channels. Select the Snapshot check box to take a snapshot of the selected channel. To use this function, select Main Menu > Advanced Settings> Camera Configuration > Video Stream > Snapshot, in the Type list, select Event. Select the check box to enable the function. When an alarm event occurs, the extra screen outputs the settings configured in Main Menu > DISPLAY > Tour > Sub Screen. ● Not all models support this function. ● To use this function, extra screen should be enabled.