IC Realtime IPFX-D80V-IRW1 Product Manual - Page 136

Icon Table 5-4 Description of smart plan icon Description Icon Description Icon Face detection Stereo vision Stereoscopic behavior analysis People counting IVS Video structralization Description Heat map Face recognition Crowd map ANPR - - Enable smart functions accord to the actual need. Different devices support different ways to enable smart functions. Select corresponding ways to enable these functions according to the actual interface.  Select an icon to enable the corresponding smart plan. Click an icon to enable it, and the selected smart function is highlighted. Click it again to cancel the selection. If there is icon on the interface, click it to enable the smart function switch.  To enable smart plan, click Add. 1) Select a preset point on the Add interface. The smart plan for the point is displayed. 2) To enable a smart function, click the corresponding icon. The selected smart function is highlighted. Click it again to cancel the selection. Click Save. Setting IVS Analysis This section Introduces scene selection requirements, rule configuration, and global configuration for IVS (intelligent video surveillance). Basic requirements on scene selection are as follows.  The target should be less than 10% of the image.  The target size in the image should not be less than 10×10 pixels. The size of abandoned object in the image should not be less than 15×15 pixels (CIF image). The target height and width should be less than a third of the image height and width. The recommended target height is 10% of the image height.  Brightness difference between the target and the background should not be less than 10 greyscale.  The target should be continuously present in the image for no less than two seconds, and Event 128