IC Realtime IPFX-D80V-IRW1 Product Manual - Page 4

Important Safeguards and Warnings Electrical safety  All installation and operation should conform to your local electrical safety codes.  The power source shall conform to the Safety Extra Low Voltage (SELV) standard, and supply power with rated voltage which conforms to Limited power Source requirement according to IEC60950-1. Please Description that the power supply requirement is subject to the device label.  Make sure the power supply is correct before operating the device.  A readily accessible disconnect device shall be incorporated in the building installation wiring.  Prevent the power cable from being trampled or pressed, especially the plug, power socket and the junction extruded from the device. Environment  Do not aim the device at strong light to focus, such as lamp light and sun light; otherwise it might cause over brightness or light marks, which are not the device malfunction, and affect the longevity of Complementary Metal-Oxide Semiconductor (CMOS).  Do not place the device in a damp or dusty environment, extremely hot or cold temperatures, or the locations with strong electromagnetic radiation or unstable lighting.  Keep the device away from any liquid to avoid damage to the internal components.  Keep the indoor device away from rain or damp to avoid fire or lightning.  Keep sound ventilation to avoid heat accumulation.  Transport, use and store the device within the range of allowed humidity and temperature.  Heavy stress, violent vibration or water splash are not allowed during transportation, storage and installation.  Pack the device with standard factory packaging or the equivalent material when transporting the device.  Install the device in the location where only the professional staff with relevant knowledge of safety guards and warnings can access. The accidental injury might happen to the non-professionals who enter the installation area when the device is operating normally. Operation and Daily Maintenance  Do not touch the heat dissipation component of the device to avoid scald.  Carefully follow the instructions in the manual when performing any disassembly operation about the device; otherwise, it might cause water leakage or poor image quality due to unprofessional disassemble. Please contact after-sale service for desiccant replacement if there is condensed fog found on the lens after unpacking or when the desiccant turns green. (Not all models are included with the desiccant).  It is recommended to use the device together with lightning arrester to improve lightning Important Safeguards and Warnings III