Konica Minolta AccurioLabel 190 bizhub PRESS C71cf/AccurioLabel 190 Quick Guid - Page 45
Connect the Media Using the workbench, WEB GRIPPER1, Roll Winder RW-101, workbench
View all Konica Minolta AccurioLabel 190 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Accurio Label 190/bizhub PRESS C71cf Connect the Media Using the workbench NOTICE NOTICE Be sure to join the edge of the media with that of another one. If media to be joined overlaps, it may cause a paper jam. " Insert the end of the media from the bottom of the media pressing bar 1. # Put the rear end of the cut media on the front end of the media to join, and then press WEB GRIPPER1 of Roll Winder RW-101 to hold the media. EMG.RESET WEB GRIPPER2 WEB GRIPPER1 STOP READY JOG $ Cut the media with following the cutter groove on the workbench. 3 After cutting, take the overlapped part away. Be careful not to cut your hand when cutting the media. 3-7
3-7
Accurio Label 190/bizhub PRESS C71cf
3
Connect the Media Using the workbench
NOTICE
NOTICE
Be sure to join the edge of the media with that of another one. If media to be joined overlaps, it may cause a paper jam.
A
Insert the end of the media from the bottom of the media pressing bar 1.
B
Put the rear end of the cut media on the front end of the media to join, and then press
WEB GRIPPER1
of
Roll Winder RW-101
to hold the media.
C
Cut the media with following the cutter groove on the
workbench
.
After cutting, take the overlapped part away.
Be careful not to cut your hand when cutting the media.
WEB
GRIPPER2
WEB
GRIPPER1
EMG.RESET
READY
JOG
STOP