Lenovo ThinkStation P300 (English) User Guide - Small Form Factor - Page 121
Pivoting the drive bay assembly upward
View all Lenovo ThinkStation P300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
This section provides instructions on how to replace the secondary hard disk drive. Note: The secondary hard disk drive is available only on some models. To replace the secondary hard disk drive, do the following: 1. Turn off the computer and disconnect all power cords from electrical outlets. 2. Remove the computer cover. See "Removing the computer cover" on page 74. 3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 74. 4. Press the release tab 1 as shown and pivot the drive bay assembly upward. Figure 62. Pivoting the drive bay assembly upward 5. Locate the secondary hard disk drive. See "Locating internal drives" on page 7. 6. Disconnect the signal cable and the power cable from the hard disk drive. 7. Remove the cable clip on the bottom of the primary hard disk drive bay as shown. Chapter 9. Installing or replacing hardware 109