Netgear STM300 STM 150-300-600 Reference Manual (PDF) - Page 54
STM150, Table 13., Network Settings, Performing Network and System Management
UPC - 606449062458
View all Netgear STM300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
ProSecure Web/Email Security Threat Management (STM) Appliance The following figure shows the Interface Speed & Duplex Settings section of the Network Settings screen of the STM150: Figure 34. STM150 2. Complete the fields and make your selections from the drop-down lists as explained in the following table: Table 13. Network Settings Setting Description (or Subfield and Description) Management Interface Settings System Name IP Address The name for the STM for purposes of identification and management. The default name is the name of your model (STM150, STM300, or STM600). Enter the IP address of the STM through which you will access the Web Management Interface. The factory default IP address is 192.168.1.201. Note: If you change the IP address of the STM while being connected through the browser, you will be disconnected. You then need to open a new connection to the new IP address and log in again. For example, if you change the default IP address from 192.168.1.201 to 10.0.0.1, you need to enter https://10.0.0.1 in your browser to reconnect to the Web Management Interface. Subnet Mask Enter the IP subnet mask. The subnet mask specifies the network number portion of an IP address. Unless you are implementing subnetting, use 255.255.255.0 as the subnet mask. Gateway Address Enter the IP address of the gateway through which the STM is accessed. Primary DNS Secondary DNS Specify the IP address for the primary DNS server IP address. As an option, specify the IP address for the secondary DNS server IP address. Interface Speed & Duplex Settings These sections show the MAC address and assigned speed and duplex setting for each active interface. The Set Speed/Duplex drop-down list allows you to select the speed and duplex setting for each active interface. To set the speed to 1000baseT duplex ("full"), select auto to let the STM sense the speed automatically. Note: MGMT stands for management interface. 54 | Chapter 3. Performing Network and System Management