Netgear STM300 STM 150-300-600 Reference Manual (PDF) - Page 55
Apply, Reset, Table 13., Network Settings Continued
![]() |
UPC - 606449062458
View all Netgear STM300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
ProSecure Web/Email Security Threat Management (STM) Appliance Table 13. Network Settings (Continued) Setting Description (or Subfield and Description) STM600 MGMT (see Figure 32 on page 53) PAIR1 UPLINK PAIR1 DOWNLINK PAIR2 UPLINK PAIR2 DOWNLINK From the Set Speed/Duplex drop-down list, make one of the following selections: • auto. Speed autosensing. This is the default setting. • 10baseT/Half. Ethernet speed at half duplex. • 10baseT/Full. Ethernet speed at full duplex. • 100baseT/Half. Fast Ethernet speed at half duplex. • 100baseT/Full. Fast Ethernet speed at full duplex. STM300 (see Figure 33 on page 53) MGMT UPLINK DOWNLINK STM150 (see Figure 34 on page 54) LAN1 LAN2 LAN3 LAN4 WAN From the Set Speed/Duplex drop-down list, make one of the following selections: • auto. Speed autosensing. This is the default setting. • 10baseT/Half. Ethernet speed at half duplex. • 10baseT/Full. Ethernet speed at full duplex. • 100baseT/Half. Fast Ethernet speed at half duplex. • 100baseT/Full. Fast Ethernet speed at full duplex. From the Set Speed/Duplex drop-down list, make one of the following selections: • auto. Speed autosensing. This is the default setting, which can sense 1000BaseT speed at full duplex. • 10baseT/Half. Ethernet speed at half duplex. • 10baseT/Full. Ethernet speed at full duplex. • 100baseT/Half. Fast Ethernet speed at half duplex. • 100baseT/Full. Fast Ethernet speed at full duplex. Note: All LAN interfaces share the same MAC address, speed, and duplex mode. Note: The STM150 does not provide a dedicated management interface. MTU Settings Maximum Transmission Unit The maximum transmission unit (MTU) is the largest physical packet size that a network can transmit. Packets that are larger than the MTU value are divided into smaller packets before they are sent, an action that prolongs the transmission process. For most Ethernet networks the MTU value is 1500 bytes, which is the default setting. Note: NETGEAR recommends synchronizing the STM's MTU setting with that of your network to prevent delays in transmission. 3. Click Apply to save your settings. (If you click Reset, the STM restarts to restore the default network settings.) Changing the network settings has the following consequences: • Changing any of the settings in the Management Interface Settings section of the screen causes the STM to restart. • Changing any of the settings in the Interface Speed & Duplex Settings section of the screen causes the network to restart. • Changing the MTU setting causes services such as HTTP and SMTP to restart. Chapter 3. Performing Network and System Management | 55
![](/manual_guide/products/netgear-stm150-stm-150300600-reference-manual-pdf-8d16fbf/55.png)