Netgear STM300 STM 150-300-600 Reference Manual (PDF) - Page 70
Reverting to Factory Default Settings, To restore settings from a backup file
UPC - 606449062458
View all Netgear STM300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
ProSecure Web/Email Security Threat Management (STM) Appliance To restore settings from a backup file: 1. On the Backup and Restore Settings screen (see Figure 41 on page 68), next to Restore save settings from file, click Browse. 2. Locate and select the previously saved backup file. 3. When you have located the file, click the Restore button. A warning screen might appear, and you might have to confirm that you want to restore the configuration. The STM restarts. During the reboot process, the Backup and Restore Settings screen remains visible. The reboot process is complete after several minutes when the Test LED on the front panel goes off. WARNING! Once you start restoring settings, do not interrupt the process. Do not try to go online, turn off the STM, shut down the computer, or do anything else to the STM until the settings have been fully restored. Reverting to Factory Default Settings To reset the STM to the original factory default settings, click the Default button next to Revert to factory default settings on the Backup and Restore Settings screen (see Figure 41 on page 68). The STM restarts. The Backup and Restore Settings screen remains visible during the reboot process. The reboot process is complete after several minutes when the Test LED (STM150) or Status LED (STM300 and STM600) on the front panel goes off. WARNING! When you restore the factory default settings, the STM settings are erased. All content settings and scan settings are lost. Back up your settings if you intend on using them. Note: After rebooting with factory default settings, the STM administrator account password is password, the guest account password is guest, and the LAN IP address is 192.168.1.201. 70 | Chapter 3. Performing Network and System Management