Netgear WAC124 User Manual For Firmware version less than 1.0.4.2 - Page 242
Check the DHCP network settings of your computer or mobile device
View all Netgear WAC124 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 242 highlights
AC2000 802.11ac Wireless Access Point/Router WAC124 Check the DHCP network settings of your computer or mobile device Make sure that the network settings of the computer or mobile device with which you want to connect to the access point/router are correct: • Access point mode. If the access point/router is in access point mode (the default system mode), the LAN subnet to which your computer or device connects depends on the type of connection to the access point/router: - Directly connected. If you are directly connected over WiFi or an Ethernet cable to the access point/router network, make sure that the IP address of your computer or mobile device is on the same subnet as the LAN subnet of the access point/router. If you are using the default addressing scheme, your device's address is in the range of 192.168.0.2 to 192.168.0.254. - Connected to the same network but not directly connected. If you are not directly connected to the access point/router, make sure that the IP address of your computer or mobile device is on the same subnet as the LAN subnet of the existing network router to which the access point/router is connected. • Router mode. If the access point/router is in router mode, make sure that the IP address of your computer or mobile device is on the same subnet as the LAN subnet of the access point/router. If you are using the default addressing scheme, your device's address is in the range of 192.168.0.2 to 192.168.0.254. Most computers and mobile devices function as DHCP clients. If your computer or mobile device does not, enable its DHCP client so that is can obtain an IP address automatically using DHCP. Standard LED behavior when the access point/router is powered on After you turn on power to the access point/router, verify that the following sequence of events occurs: 1. When power is first applied, verify that the Power LED is lit. 2. After about two minutes, verify the following: • The Power LED is solid green. • The Internet LED is solid or blinking green. Diagnostics and 242 Troubleshooting User Manual