Netgear WAC124 User Manual For Firmware version less than 1.0.4.2 - Page 4

AC2000 802.11ac Wireless Access Point/Router WAC124 Router mode: Manually set up the access point/router Internet connection 40 Router mode: Specify a dynamic or fixed WAN IP address Internet connection without a login 40 Router mode: Specify a PPPoE Internet connection that uses a login 42 Router mode: Specify a PPTP or L2TP Internet connection that uses a login 44 Router mode: Specify an IPv6 Internet connection 46 Router mode: Requirements for entering IPv6 addresses.......47 Router mode: Use Auto Detect for an IPv6 Internet connection 47 Router mode: Use Auto Config for an IPv6 Internet connection 49 Router mode: Set up an IPv6 6to4 tunnel Internet connection.51 Router mode: Set up an IPv6 6rd Internet connection 52 Router mode: Set up an IPv6 passthrough Internet connection 54 Router mode: Set up an IPv6 fixed Internet connection...........55 Router mode: Set up an IPv6 DHCP Internet connection.........57 Router mode: Set up an IPv6 PPPoE Internet connection........58 Chapter 4 Manage the Basic WiFi and Radio Features Set up or change an open or secure WiFi network 62 Configure WPA and WPA2 Enterprise WiFi security 65 Disable or enable a WiFi network 67 Hide or broadcast the SSID for a WiFi network 68 Enable or disable the WiFi radios 69 Use WPS to add a device to the WiFi network 70 Use WPS with the push button method 70 Use WPS with the PIN method 72 Chapter 5 Manage the Firewall and Security Router mode: Manage the basic firewall settings 75 Router mode: Manage port scan protection and denial of service protection 75 Router mode: Set up a default DMZ server 76 Router mode: Manage IGMP proxying 77 Router mode: Manage NAT filtering 78 Router mode: Manage the SIP application-level gateway........79 Router mode: Manage VPN pass-through 80 Allow or block device access to your network 81 Enable and manage network access control 81 Manage network access control lists 82 4