Oki X400 X400 Programming Command Manual - Page 127
UCC-128
![]() |
View all Oki X400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
UCC-128 Command Structure BIbbcccd (data) bb = ccc = d = (data) = Width of narrow element in dots (01~12) Bar height in dots (001~999) Placement of human readable text. 0 None 1 Text at top of bar code 2 Text at bottom of bar code 17 digits made up of the following: 1st digit = Container type digits 2~8, Shipper identification digits 9~17, Container sequential number Note: The Container Sequential number is not automatically sequenced by the printer. Character Set Density Table See Code 128 Character Table. See Code 128. Notes 1. The Start, Function, Stop and Extension codes will be created by the printer and added automatically. 2. The internal Modulo 10 check character will be automatically created and added by the printer. The overall Code 128 symbol check character will be automatically created by the printer and checked. 3. The automatically created human readable text will be generated according to the following rules: The spacing between bar code and text is fixed at 10 dots (.0050 inches). If the width of human readable text is wider than the bar code, it will start at the same position as the bar code and extend past the right of the bar code. If the width of human readable text is less than the bar code, it will be centered on the bar code. The automatically generated human readable text font is OCR-B. If any part of the human readable text extends outside the printable area, 125
![](/manual_guide/products/oki-data-x400-x400-programming-command-manual-82e8f1d/127.png)