Oki X400 X400 Programming Command Manual - Page 87
The Reference Point of the PDF417 symbol is the upper-left corner.
View all Oki X400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Special Notes 1. When the code words per line and the number of rows per symbol ("dd" and "ee") are set to all zeroes, the printer will calculate the optimum configuration. 2. The product of the values entered for "dd" and "ee" are not equal to or less than the value of "ffff" (i.e. "ffff" is greater than "dd" x "ee"), an error will occur and the symbol will not be printed. It is recommended that these values each be set to "000" and the printer be allowed to automatically calculate the optimum values. 3. The values of "dd" and "ee" need to be made larger if the security level is increased. 4. The maximum data length is 2700 characters, but may be less depending upon: - the minimum module dimension ("aa") - the security level specified by "c" - the number of data characters 5. The Reference Point of the PDF417 symbol is the upper-left corner. 6. The F Sequential Numbering command cannot be used with this command. 7. The E Line Feed command cannot be used with this command. 8. The Macro and Truncated PDF417 symbols are not supported. 9. The values 00H through 1FH can be specified as print data. 10. This command can be stored in a format. 11. The R Rotate command can be used. 12. The print height of the symbol will vary depending upon the data specified; numeric only, alpha only or alphanumeric. 85