Panasonic NV-GS400 Operating Instructions - Page 63

protective

Page 63 highlights

Others ambient temperature, the fogging disappears naturally. 0,4•1€64 conditions, such as temperature, humidity, dust, etc.) Video Head Clogging and Care If the heads (the parts that make contact with the tape) are dirty, mosaic-pattern noise may appear on the playback image, or the screen as a whole becomes black. If the heads are extremely dirty, recording performance deteriorates, and, In the worst case, the Movie Camera cannot record at all. Causes of Dirty Heads • Large quantity of dust in the air • High-temperature and high-humidity environment • Damaged tape • Long operating hours Using Mini-DV Format Digital Video Head Cleaner 1 Insert the Head Cleaner into the Movie Camera in the same manner as a Video Cassette. 2 Press the [►] Button, and approximately 20 seconds later, press the [U] Button. (Do not rewind the tape.) 3 Take out the Head Cleaner. Insert a Video Cassette and start recording. Then, play the tape back to check the recorded image. 4 If the image is not still clear, repeat Steps 1 to 3. (Do not use the Head Cleaner for 3 times or more consecutively.) Notes: • Do not rewind every time you use the Head Cleaner. Rewind only when the tape reaches the end, and then use it again from the beginning in the same manner as before. • If the heads become dirty soon after cleaning, the tape may be damaged. In this case, immediately stop using that Cassette. • Do not clean the heads excessively. (Excessive cleaning may cause excessive wear of the heads. If the heads are worn, images cannot be played back even after the heads are cleaned.) • If the dirty heads cannot be cleaned with the Head Cleaner, the Movie Camera needs to be cleaned at a service centre. Please consult a dealer. • Video Head Cleaners can be purchased from a service centres. • Head cleaning due to dirty heads is not considered a malfunction of the product. It is not covered by the warranty. Periodical Check-up To maintain the highest image quality, we recommend replacement of worn parts, such as heads, etc., after approximately 1000 hours of use. (This, however, depends on operating I Optimal Use of the Battery Battery Characteristics This Battery is a rechargeable lithium Ion battery. Its ability to generate power is based upon the chemical reaction that takes place Inside it. This reaction is susceptible to the surrounding temperature and humidity, and, If the temperature is too high or too low, the operating time of the Battery becomes shorter. If the Battery Is used in an extremely cold environment, the Battery may operate only for about 5 minutes. If the Battery becomes extremely hot, a protective function may operate, and the Battery may become unusable for a while. Be Sure to Detach the Battery atter Use Be sure to detach the Battery from the Movie Camera. (If it is left attached to the Movie Camera, a minute amount of current is consumed even when the Movie Camera power is off.) If the Battery is left attached to the Movie Camera for a long time, over-discharge takes place. The Battery may become unusable after it is charged. Disposing of an Unusable Battery •The Battery has a limited life. • Do not throw the Battery Into fire because it may cause an explosion. Always Keep the Terminals of the Battery Clean Prevent the terminals from getting clogged with dirt, dust, or other substances. If you drop the Battery accidentally, check to see if the Battery body and terminals are deformed. Attaching a deformed Battery to the Movie Camera or AC Adaptor may damage the Movie Camera or AC Adaptor. • Cautions for Storage Before storing the Movie Camera, take the Cassette out and detach the Battery. Store all the components in a dry place with a relatively stable temperature. (Recommended Temperature: 15 to 25°C, Recommended Humidity: 40 to 60%) Movie Camera •wrap it with a soft cloth to prevent dust from getting into the Camera. •Do not leave the Movie Camera in places that expose it to high temperature. Battery • Extremely high temperatures or low temperatures will shorten the life of the Battery. • If the Battery is kept in smoky or dusty places, the terminals may rust and cause malfunctions. •Do not allow the Battery terminals to come in contact with metal objects (such as 63

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70

Others
0,4•1€64
a
ambient
temperature,
the
fogging
disappears
conditions,
such
as
temperature,
humidity,
dust,
naturally.
etc.)
Video
Head
Clogging
and
Care
Optimal
Use
of
the
Battery
If
the
heads
(the
parts
that
make
contact
with
the
Battery
Characteristics
tape)
are
dirty,
mosaic
-pattern
noise
may
appear
This
Battery
is
a
rechargeable
lithium
Ion
battery.
on
the
playback
image,
or
the
screen
as
a
whole
Its
ability
to
generate
power
is
based
upon
the
becomes
black.
If
the
heads
are
extremely
dirty,
chemical
reaction
that
takes
place
Inside
it.
This
recording
performance
deteriorates,
and,
In
the
reaction
is
susceptible
to
the
surrounding
worst
case,
the
Movie
Camera
cannot
record
at
temperature
and
humidity,
and,
If
the
temperature
all.
is
too
high
or
too
low,
the
operating
time
of
the
Causes
of
Dirty
Heads
Battery
becomes
shorter.
If
the
Battery
Is
used
in
Large
quantity
of
dust
in
the
air
an
extremely
cold
environment,
the
Battery
may
High
-temperature
and
high
-humidity
operate
only
for
about
5
minutes.
If
the
Battery
environment
becomes
extremely
hot,
a
protective
function
may
Damaged
tape
operate,
and
the
Battery
may
become
unusable
Long
operating
hours
for
a
while.
Using
Mini
-DV
Format
Digital
Video
Head
Be
Sure
to
Detach
the
Battery
atter
Use
Cleaner
Be
sure
to
detach
the
Battery
from
the
Movie
1
Insert
the
Head
Cleaner
into
the
Movie
Camera.
(If
it is
left
attached
to
the
Movie
Camera
in
the
same
manner
as
a
Video
Camera,
a
minute
amount
of
current
is
consumed
Cassette.
even
when
the
Movie
Camera
power
is
off.)
If
the
2
Press
the
[►]
Button,
and
approximately
Battery
is
left
attached
to
the
Movie
Camera
for
a
20
seconds
later,
press
the
[U]
Button.
(Do
long
time,
over
-discharge
takes
place.
The
not
rewind
the
tape.)
Battery
may
become
unusable
after
it
is
charged.
3
Take
out
the
Head
Cleaner.
Insert
a
Video
Disposing
of
an
Unusable
Battery
Cassette
and
start
recording.
Then,
play
the
•The
Battery
has
a
limited
life.
tape
back
to
check
the
recorded
image.
Do
not
throw
the
Battery
Into
fire
because
it
may
4
If
the
image
is
not
still
clear,
repeat
cause
an
explosion.
Steps
1
to
3.
(Do
not
use
the
Head
Cleaner
Always
Keep
the
Terminals
of
the
Battery
for
3
times
or
more
consecutively.)
Clean
Notes:
Prevent
the
terminals
from
getting
clogged
with
Do
not
rewind
every
time
you
use
the
Head
dirt,
dust,
or
other
substances.
Cleaner.
Rewind
only
when
the
tape
reaches
If
you
drop
the
Battery
accidentally,
check
to
see
the
end,
and
then
use
it
again
from
the
if
the
Battery
body
and
terminals
are
deformed.
beginning
in
the
same
manner
as
before.
Attaching
a
deformed
Battery
to
the
Movie
If
the
heads
become
dirty
soon
after
cleaning,
Camera
or
AC
Adaptor
may
damage
the
Movie
the
tape
may
be
damaged.
In
this
case,
Camera
or
AC
Adaptor.
immediately
stop
using
that
Cassette.
Cautions
for
Storage
Do
not
clean
the
heads
excessively.
(Excessive
Before
storing
the
Movie
Camera,
take
the
cleaning
may
cause
excessive
wear
of
the
Cassette
out
and
detach
the
Battery.
heads.
If
the
heads
are
worn,
images
cannot
be
Store
all
the
components
in
a
dry
place
with
a
played
back
even
after
the
heads
are
cleaned.)
relatively
stable
temperature.
If
the
dirty
heads
cannot
be
cleaned
with
the
(Recommended
Temperature:
15
to
25°C,
Head
Cleaner,
the
Movie
Camera
needs
to
be
Recommended
Humidity:
40
to
60%)
cleaned
at
a
service
centre.
Please
consult
a
Movie
Camera
dealer.
•wrap
it
with
a
soft
cloth
to
prevent
dust
from
Video
Head
Cleaners
can
be
purchased
from
getting
into
the
Camera.
service
centres.
•Do
not
leave
the
Movie
Camera
in
places
that
Head
cleaning
due
to
dirty
heads
is
not
expose
it
to
high
temperature.
considered
a
malfunction
of
the
product.
It
is
not
Battery
covered
by
the
warranty.
Extremely
high
temperatures
or
low
Periodical
Check-up
temperatures
will
shorten
the
life
of
the
Battery.
To
maintain
the
highest
image
quality,
we
If
the
Battery
is
kept
in
smoky
or
dusty
places,
recommend
replacement
of
worn
parts,
such
as
the
terminals
may
rust
and
cause
malfunctions.
heads,
etc.,
after
approximately
1000
hours
of
•Do
not
allow
the
Battery
terminals
to
come
use.
(This,
however,
depends
on
operating
in
contact
with
metal
objects
(such
as
63