Panasonic PT-DZ21KU Operating Instructions - Page 101

[PROJECTOR SETUP] menu Note zzFor a set time after [LAMP SELECT] is switched, [LAMP SELECT] cannot be switched again, because the speed of the lamp replacement cycle will increase. Repeatedly switching [LAMP SELECT] in a short time will also increase the speed of the lamp replacement cycle. zzThe colors of the items indicate the status. Green → Current setting Yellow → Current setting (When there is a lamp that cannot turn on or failed to turn on) Red → Lamp that has failed to turn on White → Any other status zzWhen a lamp fails to turn on or has been used in excess of 2 000 hours*1 and a setting other than [QUAD] is selected, that lamp is turned off and another lamp turned on. When a lamp fails to turn on or has been used in excess of 2 000 hours*1 in [QUAD], a lamp that has not been used in excess of 2 000 hours*1 is turned on. The projector enters standby mode when all lamps have been used in excess of 2 000 hours*1. zzEnsure that lamp units not to be turned on are also installed. zzMore lamps than the specified number of lamps light temporarily to prevent decreased illuminance when a lamp is switched. *1: 500 hours when the optional accessory replacement lamp unit (for portrait mode) (Model No.: ET-LAD510P (1 pc), ET-LAD510PF (4 pcs)) is used. [LAMP RELAY] The lump to be turned on can be automatically switched by setting a day and time. The degradation of the lamp due to continuous usage can be reduced by automatically switching the lamp to be turned on when using the projector continuously for a week or more. 1) Press ▲▼ to select [LAMP RELAY]. 2) Press ◀▶ to switch [LAMP RELAY]. zzThe time setting to switch the lamp will change as follows each time you press the button. [OFF] [24H] [1WEEK] 6) Press the button. zzThe adjusted time is established. 7) Press ▲▼ to select [DAY OF THE WEEK]. 8) Press ◀▶ to switch [DAY OF THE WEEK]. zzThe setting will change as follows each time you press the button. [SUNDAY] [MONDAY] [TUESDAY] [WEDNESDAY] [SATURDAY] [FRIDAY] [THURSDAY] Note zzThe [LAMP RELAY] function is enabled when [SINGLE], [DUAL], [TRIPLE], or [QUAD] is selected in [LAMP SELECT]. zzWhen [SINGLE] or [DUAL] is selected in [LAMP SELECT], the lamp switches to the specified time. When [TRIPLE] is selected in [LAMP SELECT], the lamp switches a total of three times every two hours from the specified time, and thereafter maintains the previous status until the specified time. When [QUAD] is selected in [LAMP SELECT], three turn on at the specified time and the three lamps switch every two hours for a total of four times. Next, four lamps turn on eight hours after the specified time and thereafter three lamps switch again after the specified time. zzThe operating time will be the local time. ( page 110) zzUse the number ( to ) buttons on the remote control to directly enter the time. 3) Press ▲▼ to select [TIME]. 4) Press the button. zzEnters adjustment mode (the display is blinking). 5) Press ◀▶ to select [HOUR] or [MINUTE], and then press ▲▼ to adjust it. [00:00] (1 hour or 1 minute increments) [00:01] [00:59] Settings ENGLISH - 101