Panasonic PT-DZ21KU Operating Instructions - Page 27
Using the remote control, Inserting and removing the batteries, Setting Remote control ID numbers,
View all Panasonic PT-DZ21KU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Preparation Using the remote control Using the remote control Inserting and removing the batteries 1) Open the cover. (ii) (i) 2) Insert the batteries and close the cover (insert the side first). zzWhen removing the batteries, perform the steps in reverse order. Setting Remote control ID numbers When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector individually using single remote control, if a unique ID number is assigned to each projector. After setting the ID number of the projector, set same ID number on the remote control. The ID number of the projector is set to [ALL] as the factory default. When using a single projector, press the button on the remote control. Also, you can perform control operations if you push the button on the remote control even if you do not know the projector ID. ■■How to set 1) Press the button on the remote control. 2) Within five seconds, press the twodigit ID number set on the projector using the number ( - ) buttons. zzIf you press the button, you can operate the projectors regardless of the setting of the projector's ID number. Attention zzSince setting of the ID number on the remote control can be performed even without the projector, do not press the button carelessly. If the number ( - ) buttons are not pressed within five seconds after the button is pressed, the ID number returns to its original value before pressing the button. zzThe ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control is left with dead batteries. Set the same ID number again when the batteries are replaced. Note zzSet the ID number of the projector from the [PROJECTOR SETUP] menu → [PROJECTOR ID] ( page 99). Connecting to the projector with a cable When you use the system with multiple projectors, configure the units as in the following figure. Use a commercial M3 stereo mini jack cable and connect the other devices to the / terminals of the projector. The remote control is effective even in places where an obstacle stands in the light path or where devices are susceptible to outside light. Remote control Connects to the remote control wired terminal M3 stereo mini jack cable (commercially available) Connecting to a second projector Connecting terminals Attention zzUse a cable that is 15 m (49'2") or shorter, with 2 core shield. The remote control may not operate when the length of the cable exceeds 15 m (49'2") or when the shielding of the cable is inadequate. ENGLISH - 27