Panasonic PT-DZ21KU Operating Instructions - Page 86
[3d Frame Delay], [3d Test Mode], [3d Test Pattern], To Switch [3d Test Mode].
View all Panasonic PT-DZ21KU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
[3D SETTINGS] menu (PT‑DZ21KU and PT‑DS20KU only) [3D FRAME DELAY] Adjust the timing of the left-right switch of an image. 1) Press ▲▼ to select [3D FRAME DELAY]. 2) Press ◀▶ to switch [3D FRAME DELAY]. zzValues in the following range change by units of 10 us. 0 us to 25 000 us [3D TEST MODE] Set the image display format for use with 3D system adjustments. 1) Press ▲▼ to select [3D TEST MODE]. 2) Press ◀▶ to switch [3D TEST MODE]. zzThe setting will change as follows each time you press the button. [NORMAL] [SIDE BY SIDE] [LEFT/LEFT] [BLACK/ RIGHT] [LEFT/ BLACK] [RIGHT/ RIGHT] [NORMAL] Standard setting. The left eye image is displayed [SIDE BY SIDE] on the left, next to the right eye image displayed on the right. Both the left eye image and right [LEFT/LEFT] eye image display the left eye input signal. Both the left eye image and right [RIGHT/RIGHT] eye image display the right eye input signal. [LEFT/BLACK] The left eye input signal is displayed in the left eye image and a completely black image is displayed in the right eye image. A completely black image is [BLACK/RIGHT] displayed in the left eye image and the right input signal is displayed in the right eye image. Note zzThe [3D TEST MODE] settings return to [NORMAL] when the projector is switched off. zzThis is disabled when [3D SYSTEM SETTING] is set to any setting other than [SINGLE]. zzThis is disabled when [3D TEST PATTERN] is displayed. [3D TEST PATTERN] The 3D test pattern can be used to check operation and make adjustments even without a 3D signal. 1) Press ▲▼ to select [3D TEST PATTERN]. 2) Press ◀▶ to switch [3D TEST PATTERN]. zzThe setting will change as follows each time you press the button. Menu screen + Entry screen Menu screen + Left: white/ Right: black Menu screen + Left: black/ Right: white Note zzThe 3D test pattern cannot be displayed when the following inputs are selected. - VIDEO input - RGB1 input (only when [RGB IN] is set to [Y/C]) zzThis is disabled when [3D SYSTEM SETTING] is set to any setting other than [SINGLE]. Settings 86 - ENGLISH