Panasonic PT-DZ21KU Operating Instructions - Page 85
[3d Picture Balance], [dark Time Setting], English - 85
View all Panasonic PT-DZ21KU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
[3D SETTINGS] menu (PT‑DZ21KU and PT‑DS20KU only) [3D PICTURE BALANCE] Correct a shift when the brightness or color differ in the right eye and left eye images. 1) Press ▲▼ to select [3D PICTURE BALANCE]. 2) Press the button. zzThe [3D PICTURE BALANCE] screen is displayed. 3) Press ▲▼ to select an item, and press ◀▶ to adjust the setting. zzCorrect the setting value parts of the right eye image based on the left eye image. [CONTRAST] You can adjust the contrast of the colors. [WHITE BALANCE HIGH RED] Adjusts the high red white balance. [WHITE BALANCE HIGH GREEN] Adjusts the high green white balance. [WHITE BALANCE HIGH BLUE] Adjusts the high blue white balance. [BRIGHTNESS] You can adjust the dark (black) part of the projected image. [WHITE BALANCE LOW Adjusts the low red white balance. RED] [WHITE BALANCE LOW GREEN] Adjusts the low green white balance. [WHITE BALANCE LOW BLUE] Adjusts the low blue white balance. [COLOR] You can adjust the color saturation of the projected image. [TINT] You can adjust the skin tone in the projected image. [CLOCK PHASE] Adjust when the screen flickers or outline blurs. Note zz[CLOCK PHASE] settings go are enabled at simultaneous input of RGB1 and RGB2 to adjust the right eye image. zzThis is disabled when [3D SYSTEM SETTING] is set to any setting other than [SINGLE]. zzThis is disabled when [3D TEST PATTERN] is displayed. zzThis is disabled when [3D TEST MODE] is set to any setting other than [NORMAL] and [SIDE BY SIDE]. ■■To display [3D WAVEFORM MONITOR] The left eye and right eye images are divided and displayed in a waveform on the left and right. 4) Select [3D WAVEFORM MONITOR] in Step 3). 5) Press ◀▶ to switch [3D WAVEFORM MONITOR]. zzThe setting will change as follows each time you press the button. [OFF] [ON] [OFF] [ON] The 3D waveform monitor is not displayed. The 3D waveform monitor is displayed. Note zzThe 3D waveform monitor is displayed only when the [3D PICTURE BALANCE] screen is displayed. zzThe normal waveform monitor cannot be displayed in 3D images. [DARK TIME SETTING] Set the black display period to be displayed between the right eye image and the left eye image as necessary for the 3D system used. 1) Press ▲▼ to select [DARK TIME SETTING]. 2) Press ◀▶ to switch [DARK TIME SETTING]. zzThe setting will change as follows each time you press the button. [0.5 ms] [1.0 ms] [1.5 ms] [2.7 ms] [2.5 ms] [2.0 ms] Note zzThis is disabled when [3D SYSTEM SETTING] is set to any setting other than [SINGLE]. zzWhen the setting does not correspond to the 3D system in use, phenomenon such as increased crosstalk and darkening of displayed images may occur. Settings ENGLISH - 85