Samsung CLP-650N User Manual (user Manual) (ver.1.03) (English) - Page 61

Message Status Do this... Engine Fuser Low Heat Error The temperature in the fuser is abnormally low. Unplug the power cord and plug it in again. If the problem persists, call for service. Engine Fuser Over Heat Error The temperature in the fuser is abnormally high. Unplug the power cord and plug it in again. If the problem persists, call for service. Engine Fuser Inverter Error A problem has occurred in the Fuser in the printer. Unplug the power cord and plug it in again. If the problem persists, call for service. Engine LSU Error A problem has occurred in the LSU (Laser Scanning Unit) in the printer. Unplug the power cord and plug it in again. If the problem persists, call for service. Install [Color] Toner The indicated color toner cartridge is not installed in the printer. Install the corresponding color toner cartridge. Install Transfer Belt The paper transfer belt is not installed in the printer. Install the paper transfer belt. Invalid Toner [Color] An invalid toner cartridge has been installed. Only install Samsung toner cartridges, designed for your printer. Or install the toner cartridge into each proper cartridge slot. If you have installed an Samsung toner cartridge or into each proper caartridge slot and this error still occurs, contact an authorized service agent. Invalid Transfer Belt An invalid paper transfer belt has been installed. Only install Samsung paper transfer belts, designed for your printer. If you have installed an Samsung paper transfer belt and this error still occurs, contact an authorized service agent. Jam0 In Tray1 Jam0 In Tray2 Jam0 In MP Tray A paper jam has occurred in or near the indicated tray. Remove the jammed paper from the corresponding tray, referring to page 7.4. Jam In Exit Area A paper jam has occurred in the paper exit area. Remove the jammed paper from the printer, referring to page 7.7. Jam Inside Printer A paper jam has occurred inside the printer. Open the access door and remove the jammed paper from the printer, referring to page 7.6. Message Status Do this... Load [Size] In Tray1 Load [Size] In Tray2 Load [Size] In MP The paper size specified in the printer properties does not match the paper you are loading. Load the correct paper in the tray. Low Density The amount of the toner which is spread on the paper transfer belt for adjusting auto color registration is very small, so that the printer does not recognize the toner during auto color registration. Replace the toner cartridge(s) with a new one. See page 6.4. If you still have the same problem, contact a service representative. Left Fan Error A problem has occurred in the Left Fan of the printer. Unplug the power cord and plug it in again. If the problem persists, call for service. Main Motor Error A problem has occurred in the development motor of the printer. Unplug the power cord and plug it in again. If the problem persists, call for service. Memory Overflow The printer does not have enough memory to print the current job. An error has occurred in the firmware program of the printer. The job automatically clears and the printer returns to Standby Mode. Lower the print resolution and try again. Paper Empty [Size] In Tray1 Paper Empty [Size] In Tray2 Paper Empty [Size] In Mp Paper Empty [Size] In Manual The paper tray has run Load paper in the paper tray. out of paper. See page 4.2. Photo LED error During auto color registration, the printer does not recognize the photo LED in the paper transfer belt assembly. Contact a service representative. 7.15 Solving Problems