TRENDnet TEW-827DRU Users Guide - Page 48
Access Control (IP Protocol Filter), Client IP Address Range
View all TRENDnet TEW-827DRU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
TRENDnet User's Guide Access Control (IP Protocol Filter) Advanced > Security > Access Control You may want to block computers or devices on your network access to specific ports (used or required by a specific application) to the Internet. Block a specific service or multiple services 1. Log into your router management page (see "Access your router management page" on page 10). 2. Click on Advanced and click on Security, then click on Access Control. 3. Next to Enable Access Control, click the Enable option. 4. Review the Add Services Block Rule. Click Add to save the rule. Commit your changes to the router by clicking on Apply/Discard Changes in the left-hand menu, and click Apply & Reboot. Rule Enable - Checking this option turns on the Protocol/IP Filter and unchecking turns it off. Rule Name - Enter a name for the Protocol/IP Filter. Schedule (Optional) - The schedule function allows you to define a schedule when the access control filter should be turned on. T To define a new schedule, click New Schedule and refer to page 43 " Create Schedules". After you have created a new schedule, click the drop-down list and the new schedule will be available for selection. Note: Before applying scheduling, please ensure your Time settings are configured correct and you have defined a schedule. See page 42 to configure Time Settings and see page 43 " Create Schedules" to create a schedule. © Copyright 2016 TRENDnet. All Rights Reserved. TEW-827DRU Client IP Address Range - Enter the IP address or IP address range to apply the protocol/IP filter. (e.g. 192.168.10.20-192.168.10.20 or 192.168.10.20192.168.10.30). Note: The filter will not be applied to IP addresses outside of the range specified. To simplify configuration, there is a list of commonly used pre-defined Protocol/IP Filters to modify otherwise, you can choose to manually add a new Protocol/IP Filter. Service - Select Predefined to select from the predefined services listed or select Manually to specifically enter the TCP or UDP port number or port range numbers to block. (e.g. 80-80 or 20-21). 45