Yamaha DTX502 Owner's Manual - Page 61
Settings affecting entire kits, Hold Mode, Alternate Group, Double Bass Switch, Reverb Send Voices
View all Yamaha DTX502 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Advanced Techniques Setting Parameters using Menu Mode KitV12 Hold Mode >KitV12 snareHd q " HoldMode=off , w q Trigger input source See q Trigger input source from the description of the KitV1 page. The setting made on this page applies to both Layer A and Layer B. w HoldMode Use this parameter to turn Hold mode on or off for voices produced by the specified trigger input source. Settings on off Description MIDI Note On and Note Off messages are output alternately whenever the pad is struck. Note that when Wave Voice (W) has been specified as the voice category, the Wave Voice will be played repeatedly. This setting corresponds to normal operation: A MIDI Note On message is output when the pad is struck, and the corresponding MIDI Note Off message is output automatically after the gate time has elapsed. KitV13 Alternate Group >KitV13 snareHd q " AltGrp=off w q Trigger input source See q Trigger input source from the description of the KitV1 page. The setting made on this page applies to both Layer A and Layer B. w AltGrp Use this parameter to assign the voices produced by the specified trigger input source to an alternate group-that is, a collection of voices that you do not want to play simultaneously, such as open and closed hi-hats. If a voice is triggered while another from the same alternate group is already playing, the earlier voice will be silenced before the new one is played. Settings off HHOpen HHClose 1 to 9 Description Voice is not assigned to an alternate group Open Hi-hat group Closed Hi-hat group Numbered alternate groups: Voices that you do not want to play simultaneously can be freely assigned to them. NOTE The Open Hi-hat group and the Closed Hi-hat group operate according to the following rules. • When a voice from the Open Hi-hat group is triggered, other voices from that group and those from the Closed Hi-hat group are not silenced. • When a voice from the Closed Hi-hat group is triggered, all voices from the Open Hi-Hat group are silenced. 03: KitCommon Area Settings affecting entire kits The KitCommon area is used to set parameters that apply to the current kit. KitC1 Double Bass Switch >KitC1 " DblBass=off , q q DblBass By setting this parameter to "on", you can easily configure your drum module to produce a kick drum sound whenever you operate the pedal connected to the [HI-HAT CONTROL] trigger input jack. This convenient function provides support for double bass drumming techniques. Settings off or on NOTE Opening and closing of the hi-hat is not possible when DblBass is set to "on". KitC2 Reverb Send (Voices) >KitC2 " ReVSendDr= 60, q q RevSendDr Use this parameter to specify the level at which all of the current kit's drum voices are to be sent to the built-in reverb unit. Settings 0 to 127 NOTE The RevSendDr parameter affects all of the current kit's drum voices. To adjust the reverb level for individual pads or trigger input sources, use the Reverb Send (Source) parameter (RevSend) from the KitVoice area (page 60). DTX502 Owner's Manual 61