Yamaha DTX700 Reference Manual - Page 29

KIT Low Resonance (LowQ), Low Mid Resonance (LowMidQ), High Mid Resonance (HighMidQ), and High Resonance (HighQ) Use these parameters to specify widths for the low, low-mid, high-mid, and high frequency bands, respectively. If you set a large value, a narrower band of frequencies will be affected and the tone will change markedly around the center frequency. If you set a smaller value, a wider band of frequencies will be affected and the tone will change gradually around the center frequency. Settings: 0.1 to 12.0 Q=0.1 Q=12.0 Frequency (Hz) For pad-related settings  List of Functions Pad PadCtrlType HH Func HH MIDI Ch HH MIDI Type SnaresOn/Off SnaresAdjust SnareBuzz ResonanceLevel KIT/PAD 1/3 KIT/PAD Center frequency NOTE • If the LowShape or HighShape parameter has been set to "shelving", the corresponding width (Q) setting will be displayed as "---" and modification will not be possible. LowShape and HighShape Use these parameters to set EQ types for the low and high frequency bands, respectively. Settings: shelving, peaking • Shelving Signals at all frequencies either above or below the specified frequency will be boosted or cut. EQ low Gain Center frequency EQ high Gain Center frequency Frequency (Hz) Frequency (Hz) • Peaking Signals at frequencies in the vicinity of the center frequency will be boosted or cut. Gain Center frequency Frequency (Hz) Pad Control Type (PadCtrlType) When a pad featuring a pad controller is connected to the DTX700, this parameter can be used to assign a function to it. Before making a setting, be sure to press the [F1] button (PAD) and select the trigger input jack that the pad in question has been plugged into. off No function is assigned to the pad controller. snares By turning the pad controller, you can change the settings of the SnaresOn/Off (Snare Wire On/Off) and SnaresAdjust (Snare Wire Adjustment) parameters (also from the Menu area's Kit/Pad page), thus adjusting the tightness of the snare wire. For example, turning the pad controller counter-clockwise progressively loosens the snare wire, ultimately removing it from the snare. Turning the pad controller clockwise tightens the snare wire. If the snare wire is in the removed condition, turn the pad controller clockwise to bring it into contact with the snare. tuning By turning the pad controller, you can change the setting of the Tune (Tuning) parameter from the Menu area's Kit/Voice page, thus adjusting the pitch of the drum voice. For example, turning the pad controller counter-clockwise lowers the pitch and vice-versa. By turning the pad controller, you can adjust the song or tempo click-track tempo. Whenever you are doing so, the dis- play will show the tempo setting. By turning the pad controller, you can change the setting of the Filter parameter from the Menu area's Kit/ filter Voice page, thus adjusting the tone of the drum voice. For example, turning the pad controller counter-clockwise darkens the tone and vice-versa. snares On/Off By turning the pad controller, you can switch the SnaresOn/Off (Snare Wire On/Off) parameter (also from the Menu area's Kit/Pad page) from "off" to "on" and vice-versa. For more details, refer to Internal Design of the DTX700 (see page 3). DTX700 Reference Manual 29