Yamaha PM5D Owner's Manual - Page 27
Connections and setup, Audio connections - rear panel
View all Yamaha PM5D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
4 Connections and setup This chapter explains how to make audio input/output connections, and how to perform the setup required when starting the PM5D for the first time. Audio connections 4 Analog audio connections PM5D model Synthesizer Microphone PM5D-RH model Synthesizer Microphone Microphone Connections and setup Effect processor INPUT jacks 1-48 are used mainly to connect microphones or monaural line-level devices. ST IN jacks 1-4 are used mainly to connect stereo line-level devices. Input signal sensitivity, pad on/off, and phantom power (+48V) on/off are controlled from the top panel AD IN section (➥ p.36). INPUT jacks 1-48 and ST IN jacks 1-4 can both be used to connect microphones or line-level devices. Input signal sensitivity and phantom power (+48V) on/off are controlled from within the display (➥ p.36). However, all phantom power can be switched on/off as a whole by the rear panel [+48V MASTER] switch. On either model, the default state is for the input signals from INPUT jacks 1-48 to be patched to input channels 1- 48 and the input signals from ST IN jacks 1-4 to be patched to the ST IN channels. However, this can be changed if desired. (For details on returning the patching to its default state ➥ p.32) PM5D/PM5D-RH Owner's Manual Operating section 27