Yamaha RX-A830 RX-A830 Owners Manual - Page 18
-channel system, using presence speakers, Connecting speaker cables, Connecting the subwoofer
View all Yamaha RX-A830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
1 2 Speaker connections 3 4 5 6 7 8 9 10 7.1-channel system (using presence speakers) 6.1-channel system EXTRA SP ZONE2/F.PRESENCE The unit (rear) CENTER FRONT SPEAKERS CENTER SURROUND 1 2 SUBWOOFER SURROUND BACK/BI-AMP SINGLE EXTRA SP ZONE2/F.PRESENCE The unit (rear) CENTER FRONT SPEAKERS CENTER SURROUND 1 2 SUBWOOFER SURROUND BACK/BI-AMP SINGLE Q 1 2 W 9 3 4 5 1 2 9 3 4 8 5 ■ Connecting speaker cables Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent confusion, connect the black wire to the negative and the other wire to the positive terminal. a Remove approximately 10 mm (3/8") of insulation from the ends of the speaker cable and twist the bare wires of the cable firmly together. b Loosen the speaker terminal. c Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the terminal. d Tighten the terminal. + (red) c b FRONT - (black) da Using a banana plug (U.S.A., Canada, China, Australia and General models only) a Tighten the speaker terminal. b Insert a banana plug into the end of the terminal. a Banana plug FRONT b When using only one surround back speaker, connect it to the SINGLE jack (L side). ■ Connecting the subwoofer Use an audio pin cable to connect the subwoofer. Audio pin cable PREPARATIONS ➤ Connecting speakers En 18