Bosch WFMC5301UC Installation and Use & Care (all languages) - Page 24

Fault Possible cause Action Water is flowing out from underneath the machine. Suds coming out of the detergent dispenser. The thread of the supply hose is not tight. Leak in the drain hose. Too much soap or non-HE soap used, pump could not remove suds. Tighten the thread. Replace the drain hose. Mix 1 tablespoon of fabric softener with 1 pt (½ litre) of water and pour into detergent dispenser III. Repeated spinning. The laundry was not spun. Program duration exĆ tended. This is not a fault. The imbalance compensation system is attempting to balance the load through repeated spins. Large items of clothing have become entangled and could not be distributed evenly in the drum. For safeĆ ty reasons the highćspeed spin cycle was automatiĆ cally suppressed. This is not a fault. The suds detection feature has activated an addiĆ tional rinsing cycle to reduce the amount of suds. This is not a fault. The imbalance compensation system is attempting to balance the load through repeated spins. Use less detergent for future wash loads. Detergents specifically designed for you High Efficientcy washer produce fewer suds and will include the letters HE" on the packaging. Always load the drum with large and small items together. Always load the drum with large and small items together. Add a more appropriate amount of detergent. Always load the drum with large and small items together. Unsatisfactory washing result. The degree of soiling was higher than estimated. Select suitable program or Heavy duty as an additional option. Detergent residue on the laundry. Gray residue on the launĆ dry. System shakes or shudders when passing from lower to higher speed spinning. Not enough detergent. Some phosphateĆfree detergents contain waterĆinsolĆ uble residues that may appear as light spots on the laundry. Dirt accumulation from ointments, fats or oils. Drum system suspension can shift during speed up, this is not a failure. Add detergent according to the manufacturer's specifications. Brush off spots when laundry is dry. Add the maximum amount of detergent and select the highest permissible temperature. Mix small and large laundry pieces in load to minimize this effect. If the fault cannot be eliminated with the aid of the above table, switch the appliance off, wait 5 seconds, switch the appliance on again, select and start the program. If the fault continues, call customer service; see Page 25. 24