Bosch WFMC5301UC Installation and Use & Care (all languages) - Page 9

Attention - will not open

Page 9 highlights

Water drainage ATTENTION Do not bend or pull the water drainage hose. Height difference between the installation location of the washing machine and the drainage point: Maximum 8 feet / 244 cm, minimum 2 feet / 60 cm. Connecting the water drainage hose q Do not remove the screw from the clamp assembly. Loosen the screw only enough so that the clamp will slide freely onto the water drain hose. 2. Attach the drain hose to the drain hose connection on the back of the appliance; position the hose clamp approximately 3/8 inch (9 mm) from the end of the hose. 3. tighten the clamp with a screwdriver Standpipe Installation q Use a strap or cable tie to hold hose in place. Drainage into a siphon q Use the elbow. Attach the elbow to the end of the hose and insert end of hose into standpipe. q Use a strap or cable tie to hold hose in place. In-Wall Installation q Secure the connection point with a hose clip(not included in factory-supplied equipment). Drainage into a sink ATTENTION Ensure that the plug is not in the drain hole. 1. Place the hose clamp over the end of the drain hose before attaching the drain hose to the appliance. q Use the elbow. Attach the elbow to the end of the hose and insert the end of the hose into the wall drain. q The hose and elbow should extend into the open drain pipe as far as the elbow allows when seated as shown in the above picture. q Attach water drain hose securely to sink. q Use a strap or cable tie to hold hose in place. q When the water is being drained, check that the water flow out of the sink is adequate. 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88

9
Water
drainage
ATTENTION
Do
not
bend
or
pull
the
water
drainage
hose.
Height
difference
between
the
installation
location
of
the
washing
machine
and
the
drainage
point:
Maximum
8
feetĀ±/
244
cm,
minimum
2
feet
/
60
cm.
Connecting
the
water
drainage
hose
q
Do
not
remove
the
screw
from
the
clamp
assembly.
Loosen
the
screw
only
enough
so
that
the
clamp
will
slide
freely
onto
the
water
drain
hose.
1.
Place
the
hose
clamp
over
the
end
of
the
drain
hose
before
attaching
the
drain
hose
to
the
appliance.
2.
Attach
the
drain
hose
to
the
drain
hose
connection
on
the
back
of
the
appliance;
position
the
hose
clamp
approximately
3/8
inch
(9
mm)
from
the
end
of
the
hose.
3.
tighten
the
clamp
with
a
screwdriver
Standpipe
Installation
q
Use
the
elbow.
Attach
the
elbow
to
the
end
of
the
hose
and
insert
end
of
hose
into
standpipe.
q
Use
a
strap
or
cable
tie
to
hold
hose
in
place.
In-Wall
Installation
q
Use
the
elbow.
Attach
the
elbow
to
the
end
of
the
hose
and
insert
the
end
of
the
hose
into
the
wall
drain.
q
The
hose
and
elbow
should
extend
into
the
open
drain
pipe
as
far
as
the
elbow
allows
when
seated
as
shown
in
the
above
picture.
q
Use
a
strap
or
cable
tie
to
hold
hose
in
place.
Drainage
into
a
siphon
q
Secure
the
connection
point
with
a
hose
clip(not
included
in
factory-supplied
equipment).
Drainage
into
a
sink
ATTENTION
Ensure
that
the
plug
is
not
in
the
drain
hole.
q
Attach
water
drain
hose
securely
to
sink.
q
Use
a
strap
or
cable
tie
to
hold
hose
in
place.
q
When
the
water
is
being
drained,
check
that
the
water
flow
out
of
the
sink
is
adequate.