Dell PowerVault 130T DLT Service Manual - Page 53
P980 - Drive 3
View all Dell PowerVault 130T DLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
PowerVault 130T Service Manual CAUTION: When sliding the drive into its bay, make sure the tape drive interface cable (with connectors P980-P983) is out of the way. Do not force the tape drive into the drive slot. 8. Slide the drive into its slot, being careful not to catch or crush any cables. 9. Tighten the two thumbscrews on the back of the drive assembly. CAUTION: Before connecting the external SCSI cables, make sure there is no activity on the SCSI bus. Do not connect to a hot bus. Any third party software must be quiesced. All signals must be terminated at each end of the SCSI bus. Do not mix single-ended and differential terminators. 10. Connect the SCSI cables and/or terminator to the SCSI connectors on the rear of the tape drive. CAUTION: The tape drive interface cable (P980-P983) marking faces the rear of the tape drive. Note this orientation when reinstalling. The connector is keyed but it is still possible to insert it incorrectly. 11. Connect the tape drive interface cable to the tape drive interface connector on the tape drive. The connectors are numbered: P980 - Drive 3 P981 - Drive 2 P982 - Drive 1 P983 - Drive 0 4473D DLT Drive Tray Assembly 3-17