Dell PowerVault 130T DLT Service Manual - Page 67
library using a Torx driver with a T-15 bit., Install the lower theta stop to the floor of
View all Dell PowerVault 130T DLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
PowerVault 130T Service Manual 14. Replace the CYH card cover over the CYH card, being careful to place the various cables under the card. 15. Replace the screw holding the CYH card cover using a Torx driver. 16. Install the two upper theta stops to the ceiling of the library using a Torx driver with a T-15 bit. 17. Install the lower theta stop to the floor of the library using a Torx driver with a T-15 bit. 18. Make sure the reach mechanism on the hand assembly is fully retracted by pushing the cartridge picker into the hand assembly. 19. Proceed to the checkout procedures on page 3-43. Hand/Camera Assembly 4473D 3-31
PowerVault 130T Service Manual
Hand/Camera Assembly
4473D
3–31
14. Replace the CYH card cover over the CYH
card, being careful to place the various
cables under the card.
15. Replace the screw holding the CYH card
cover using a Torx driver.
16. Install the two upper theta stops to the
ceiling of the library using a Torx driver
with a T-15 bit.
17. Install the lower theta stop to the floor of the
library using a Torx driver with a T-15 bit.
18. Make sure the reach mechanism on the hand
assembly is fully retracted by pushing the
cartridge picker into the hand assembly.
19. Proceed to the checkout procedures on page
3–43.