Epson PowerLite Pro Z8150NL User Manual - Page 100

Problem Solving 100 Status Cause No Air Filter Air Flow Sensor Err. Low Air Flow Air Filter Notice Remedy or Status Check that the air filter is securely installed. s p.122 The projector automatically turns off about one minute after it detects that there is no air filter. If the error continues even though an air filter is installed, the air filter sensor may be defective. Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.114 (This is not an abnormality. However, projection stops automatically if the airflow falls any further.) The message "The air filter is clogged. Clean or replace the air filter." is displayed. Check the following two points. • Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall. • If the air filter is clogged, clean or replace it. s p.116, p.122 If the Low Air Flow status continues after cleaning the air filter, replace the air filter with a new one. s p.122 If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.114 "Time to clean the air filter. Clean or replace the air filter." is displayed. Clean the air filter. s p.116 If the air filter is stained yellow with tobacco smoke and cannot be cleaned, replace it with a new one. The indicators or messages regarding "Air Filter Notice" are displayed only when Air Filter Notice is set to On, on the configuration menu's Extended menu. s p.67 q • If the projector is not operating properly, even though the indicators are all showing normal, refer to "When the Indicators Provide No Help". s p.101 • If the error is not indicated in this table, stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.114