Epson PowerLite Pro Z8150NL User Manual - Page 98

Problem Solving 98 Status Cause Lamp Error Lamp Failure Filter Airflow Error Auto Iris Error Cinema filter error Shutter Error Power Err. (Ballast) Remedy or Status Check the following two points. • Take out both lamps and check if they are cracked. s p.119 • Clean the air filter. s p.116 If it is not cracked: Re-fit the lamp and turn on the power. If the error continues: Replace the lamp with a new lamp and turn on the power. If the error continues: Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.114 If it is cracked: Replace it with a new lamp, or contact Epson for further advice. If replacing the lamp yourself, be careful to avoid pieces of broken glass (you cannot continue projecting until the lamp is replaced). s p.114 When using at an altitude of 4921 ft (1500 m) or more, set High Altitude Mode to On. s p.67 Set Direction to Pointing Down, Pointing Up, Angled Up, or Angled Down when the projector is installed in a direction which is not horizontal. s p.67 Check the following two points. • Check that the air filter and air exhaust vent are clear, and that the projector is not positioned against a wall. • If the air filter is clogged, clean or replace it. s p.116, p.122 If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.114 Stop using the projector, disconnect the power cable from the electrical outlet, and contact Epson. s p.114