Fujitsu DL3700 User Manual - Page 125
Using, Setup, Changing, Configuration, Options, User's, Manual
View all Fujitsu DL3700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
USING SETUP MODE 5. Exit setup mode, saving the top-of-form setting. Make sure that the red cursor is positioned beneath SAVE & END, then press the FONT button or the MENU button. 6. Check the top-of-form setting. Load your paper and check the adjustment by printing a sample page using your software. If necessary, reenter setup mode and fine-tune the top-of-form position by changing the option. CHANGING CONFIGURATION OPTIONS The CONFIG function defines the printer's primary configuration. You can set the following options to ensure that the printer meets your requirements: • Tear off for continuous forms • Autoloading of single sheets • Direct decoding of certain commands • Enabling of the AREA OVER indicator Table 5.6 describes the CONFIG items and options. Items are listed in the order they are printed. The procedure for changing the configuration options is described after Table 5.6. Table 5.6 CONFIG Hems and Options NOTE Underlined options are the factory defaults. CONFIG Items Options Description Auto or manual tearoff feed. MANUAL Automatic tearoff feed is invalid, and tearoff feed must be done using the ID TEAR OFF button. V AUTO Automatic tearoff feed is valid but only for continuous forms. Tearoff feed can also be done using the TEAR OFF button. User's Manual 5-37