Fujitsu DL3700 User Manual - Page 64

PAPER HANDLING Loading Continuous Forms (Push Tractor and Rear Feed) This section explains how to use continuous forms as the tractor unit is installed at the rear of the printer. The tractor unit pushes continuous forms. This condition applies when you first purchase the printer. You can use continuous forms paper even if you have a cut sheet New feeder installed. However, we recommend that continuous forms paper be loaded before the feeder installed. To load continuous forms paper 1. Make sure that the printer is turned on. Remove any singlesheet paper from the printer. 2. If necessary, readjust the paper thickness lever for continuous forms. (See the section Adjusting for Paper Thickness earlier in this chapter.) 3. Move the paper select lever to the rear of the printer. Cut sheet stand • 3- 14 Back cover Paper select lever Preparing to load continuous forms paper 4. To access the forms tractors, move the cut sheet stand down into the horizontal position. Then raise the stand and the back cc together, resting them on the front of the printer. User's Manual