Fujitsu DL3700 User Manual - Page 29
Installing, sheet, stand, column, printer
View all Fujitsu DL3700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
SETTING UP 3. Hold the cut sheet stand at an angle over the top of the printer. Slide the mounting pins into the long, front grooves of the notches. This is the cut sheet stand's up position, used for printing single sheets. To rotate the cut sheet stand to its down position, grasp it at the sides and lift it up until the two upper mounting pins fall into the rear grooves of the notches. This position is used for printing most continuous forms. (136-column printer) 1. As shown below, tilt the cut sheet stand at an angle of about 45 degrees backward over the top of the printer. Slide the inside top mounting pins of the cut sheet stand into the inner grooves of the back cover. Then rest the outside pins of the cut sheet stand on the top grooves of the back cover. This is the cut sheet stand's up position, which is used for printing single sheets. Mounting pin f Cut sheet stand "mow amenimm•i User's Manual Installing the cut sheet stand (136-column printer) p 2-7