Fujitsu DL3700 User Manual - Page 55

USING SINGLE SHEETS war User's Manual PAPER HANDLING nimmome Table 3.2 Paper Thickness Lever Seffings Number of Copies (Including the Original) *1 Setting 12 1 copy 1 2 copies 2 3 copies 3 4 copies 4 5 copies 5 Ribbon replacement D *1 For carbon-interleaved paper, the carbon counts as one copy. *2 Vary the setting up or down (including A to D) to optimize printing. Select D when replacing a ribbon or clearing a paper jam. For labels and envelopes, use trial-and-error to determine a satisfactory setting. NOTE If printing is messy, the ribbon misfeeds, or the paper jams, move the lever one setting higher. This section describes how to load paper in the cut sheet stand or cut sheet feeder. The cut sheet stand allows paper to be loaded manually, one sheet at a time. A cut sheet feeder allows paper to be loaded automatically from a stack. Loading a Single Sheet of Paper To load a sheet of paper into the cut sheet stand: 1. Make sure that the printer is turned on. Check that rear-fed continuous forms are retracted to the park position. (For details, see the section Unloading Continuous Forms later in this chapter.) 3-5