Fujitsu DL3700 User Manual - Page 58

PAPER HANDLING Loading Paper in the Cut Sheet Feeder (Option) A cut sheet feeder allows automatic printing on single sheets without the need to manually insert the sheets one-by-one. This can save you a lot of time when printing long files using single sheets. The 80-column printer uses an ASF100 cut sheet feeder; the 136-column printer use ASF300 cut sheet feeder. See Chapter 8 for more information on miaow sheet feeders including a double-bin adapter. The cut sheet feeder cannot be used with pull-tractor feeding (see the section Using Continuous Forms later in this chapter). Before mounting the feeder on your printer, remove the two blank covers from the separator (open the separator and release the cover lock hooks from behind the separator). For installation of the feeder, refer to its isPr's manual. When a feeder is mounted, the printer mechanically knows the feeder type and controls the feeder accordingly. The following procedure is for the ASF300 cut sheet feeder. The same procedure is used for the ASF100 cut sheet feeder. NOTES The rear tabs of the ASF100 cut sheet feeder are the same as the bin levers of the ASF300. The ASF100 cut sheet feeder does not have paper guide locking levers. To load paper in the cut sheet feeder. 1. Make sure that the printer is turned on and continuous forms are retracted to the park position. (For details, see the section Unloading Continuous Forms later in this chapter.) 2. If necessary, reset the paper thickness lever. (See the section Adjusting for Paper Thickness earlier in this chapter.) 3. Move the paper select lever forward. (This lever is at the top left corner of the printer.) 4. Prepare the feeder as follows: 3-8 User's Manual