Fujitsu DL3700 User Manual - Page 42
Setting, Connecting, Printer, Computer
View all Fujitsu DL3700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
SETTING UP CONNECTING THE PRINTER TO YOUR COMPUTER Your printer has a Centronics parallel interface. An RS-232C serial interface is a factory-installed add-on option. Installation of the serial option gives a dual interface where either interface can be connected. The parallel interface connector has wire clips. The serial interface connector has tapped holes. Cables for both interfaces are available from dealers, cable manufacturers, and other suppliers. For detailer. interface specifications, see Appendix D. Selecting a Parallel Interface Cable For the parallel interface, use a cable that meets the following specifications: II At the printer end, use a shielded male Centronics connector, such as an Amphenol DDK 57FE-30360 or its equivalent. To prevent RFI (radio frequency interference), the connector cover must be connected to the cable shield. .4 At the computer end, most computers (including IBM PCs) require a male DB-25P connector. Some computers, however, require a Centronics connector. To determine the type of connector your computer uses, refer to your computer user manual. Make sure that the cable length does not exceed 3 meters (10 feet). Selecting a Serial Interface Cable For the serial interface, use a cable that meets the following specifications: At the printer end, use a 25-pin male connector, such as a Cannon DB-25P or its equivalent. To determine the type of connector your computer requires, refer to your computer user manual or ask your dealer. 11 The cable length can be up to 15 meters (50 feet). This type c length is required in many networking and shared-printer configurations. 2-20 User's Manual