Fujitsu DL3700 User Manual - Page 214
Serial, Options, Cable, Wiring
View all Fujitsu DL3700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 214 highlights
INTERFACE INFORMATION Serial Options The serial options for the computer and the printer must match. Use the printer control panel, the computer operating system, or your software to change options specified as "selectable." Transmission mode: Asynchronous, full duplex, or half duplex (selectable) Speed: 150, 300, 600, 1200, 2400, 4800, 9600, or 19200 baud (selectable) Data bits: 7 or 8 bits (selectable) Parity bit Odd, even, mark, space, or none (selectable) Start bit 1 bit Stop bit 1 or 2 bits (selectable) Protocol: XON/XOFF (DC1/DC3), DTR (Data Terminal Ready), or RC (Reverse Channel) (selectable) Buffer size: 0, 256, 2K, 8K, 24K, 32K, or 128K bytes (selectable) Cable Wiring This printer allows two types of serial communication control: DSRenabled and DSR-disabled. The type of control required is determined by your computer requirements. The type of control also affects the way the interface cable is wired. To determine whether you need DSRenabled control or DSR-disabled control, use the printer HARDWRE function (see Chapter 5). DSR-disabled control offers simpler cabling and communication than does DSR-enabled control. DSR-disabled control can be used to interface with an IBM PC and most other personal computers. With DSR-disabled control, the input control signals DSR, CTS, and CD aalways considered high, regardless of their actual states. Therefore,'Nof wire connection for these pins is required. The following figure shows the wiring required for connection to an IBM PC. D-6 User's Manual