Garmin G500 Pilots Guide - Page 112

Foreword System Sec 1 PFD Sec 2 MFD Sec 3 Figure 3-71 Date and Time Values 4) A Time Offset may be entered by using the large and small MFD knobs to change the values. Press ENT after completing any changes. 5) Press the small MFD knob to exit adjustments. 3.4.1.6 MFD Display Units The MFD Display Units options allow you to select the units of measurement conventions displayed on the MFD. Distance and Speed selections are Imperial, Metric, or Nautical. Altitude and Vertical speed selections are Feet or Meters. 1) While viewing the System Setup page of the AUX page group, press the small MFD knob to activate the cursor. Turn the large MFD knob to highlight the Distance and Speed (DIS, SPD) units of measurement. Features Avoidance Hazard Sec 4 Additional Sec 5 & Alerts Annun. Sec 6 Symbols Sec 7 Appendix A Glossary Sec 8 Figure 3-72 Distance and Speed MFD Display Units 2) Turn the small MFD knob to select Imperial, Metric, or Nautical and then press ENT. The Altitude and Vertical Speed units selection will now be highlighted. 3) Turn the small MFD knob to select Feet or Meters and then press ENT. 3-48 Garmin G500 Pilot's Guide 190-01102-02 Rev. B Index Appendix B