Garmin G500 Pilots Guide - Page 58
Changing CDI Course
View all Garmin G500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Foreword System Sec 1 PFD Sec 2 1) Press the CDI soft key to toggle between GPS and VOR/LOC source type. 2) Press 1-2 soft key to toggle between the 1 and 2 navigators of the GPS or VOR/ LOC sources. 3) Verify the navigation source by the indication on the HSI and in the upper left corner of the PFD. NOTE: The selected navigator is the active navigator for all PFD and MFD operations, except for the supplemental bearing pointers. 2.7.2 Changing CDI Course The Selected Course is shown to the upper left of the HSI for 10 seconds after being adjusted. New Course Setting Figure 2-28 Course Setting 1) Press the CRS key to activate Course mode. 2) Turn the PFD knob to change the Course values. OR 3) Press the PFD knob to set a Course that will center the CDI to the VOR station or waypoint if in GPS OBS mode. MFD Sec 3 Features Avoidance Hazard Sec 4 Additional Sec 5 & Alerts Annun. Sec 6 Symbols Sec 7 Appendix A Glossary Sec 8 Index Appendix B 2-18 Garmin G500 Pilot's Guide 190-01102-02 Rev. B