Garmin G500 Pilots Guide - Page 94
Traffic Feature Options Optional
View all Garmin G500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 94 highlights
Foreword System Sec 1 PFD Sec 2 MFD Sec 3 3.3.10.3 Traffic Feature Options (Optional) The Traffic group selection from the Map Setup Page Menu allows you to customize the display of traffic on the Navigation Map. The Traffic function requires the installation of the appropriate traffic device. TIS and TAS cannot be displayed at the same time. If the aircraft has a TAS unit installed, the GDU 620 will be configured for TAS. If no TAS unit is installed and a GTX Mode-S transponder is installed then the GDU 620 will be configured for TIS. A pilot can tell which data is being displayed by the label in the top left corner (TAS OPERATING vs TIS OPERATING). TIS data comes from a GTX transponder. Coverage is limited to specific areas as shown in the AIM. TAS data comes from a TAS unit such as a Skywatch 497, KTA 810, or other unit. Coverage follows the airplane. In the Navigation Map page setup you can select the maximum range at which traffic symbols are shown. Once outside of the selected range, traffic will be decluttered. The Traffic soft key will still be available. Note: Traffic is automatically decluttered from Nav Map 1 and 2 when the map scale is above 150 NM. Traffic Selection Off All Traffic TA/PA TA Only Display Result No traffic displayed All types of traffic displayed Traffic Alerts and Proximity Alerts displayed Traffic Alerts Only displayed Table 3-3 Navigation Map Traffic Display Options Features Avoidance Hazard Sec 4 Additional Sec 5 & Alerts Annun. Sec 6 Symbols Sec 7 Appendix A Glossary Sec 8 Index Appendix B Figure 3-48 Navigation Map Page Menu Traffic Group Selection 1) While viewing the Navigation Map Setup page and the Traffic Group active, turn the large MFD knob to highlight the "Traffic" options. 3-30 Garmin G500 Pilot's Guide 190-01102-02 Rev. B