Garmin G500 Pilots Guide - Page 226

Foreword System Sec 1 PFD Sec 2 MFD Sec 3 Features Avoidance Hazard Sec 4 5.4.1 Using SafeTaxi® Any map page that displays the navigation view can also show the SafeTaxi® airport layout within the maximum configured range. The following is a list of pages where the SafeTaxi feature can be seen: • Navigation Map Page • NDB Information Page • Weather Datalink Page • VOR Information Page • Airport Information Page • User Waypoint Information Page • Intersection Information Page During ground operations the aircraft's position is displayed in reference to taxiways, runways, and airport features. When panning over the airport, features such as runway holding lines and taxiways are shown. 5.4.1.1 Decluttering The DCLTR soft key (declutter) label advances to DCLTR-1, DCLTR -2, and DCLTR-3 each time the soft key is selected for easy recognition of decluttering level. Selecting the DCLTR soft key removes the taxiway markings and airport feature labels. Selecting the DCLTR-1 soft key removes VOR station ID, the VOR symbol, and intersection names if within the airport plan view. Selecting the DCLTR-2 soft key removes the airport runway layout, unless the airport in view is part of an active route structure. Pressing the DCLTR-3 soft key cycles back to the original map detail. With Auto-Zoom enabled, the map will automatically zoom to 1 NM and DCLTR-0 upon landing so SafeTaxi can be viewed. Refer to Map Declutter Levels in the Navigation Map Section. 5.4.1.2 Hot Spot Information Hot Spots can contain more information about the area that can be displayed when selected. 1. While viewing the Hot Spot area on the Navigation Map page, press the small MFD knob to activate the cursor. 2. Turn the MFD knobs to move the cursor on the Hot Spot border or into the Hot Spot area and then press the ENT key. Additional Sec 5 & Alerts Annun. Sec 6 Symbols Sec 7 Appendix A Glossary Sec 8 Index Appendix B 5-14 Garmin G500 Pilot's Guide 190-01102-02 Rev. B