Garmin G500 Pilots Guide - Page 208

Foreword System Sec 1 1) While viewing the Weather Radar page of the Wx page group, press the CONTROL soft key. 2) Press the GAIN CAL soft key to restore the calibrated gain value. Press the MFD knob again to accept the value and end editing. 4.8.6.5 Sector Scan Adjusting the Sector Scan reduces the scan angle from Full in increments of ±20°, ±40°, and ±60° in horizontal scanning. Sector scanning is not available for vertical scanning. 1) While viewing the Weather Radar page of the Wx page group, press the CONTROL soft key. 2) Press the BRG soft key to display the Bearing Line. 3) Turn the small MFD knob to place the Bearing Line in the desired position. The location of the Bearing Line will become the center point of the Sector Scan. 4) Turn the large MFD knob to place the cursor in the SECTOR SCAN field. PFD Sec 2 MFD Sec 3 Features Avoidance Hazard Sec 4 Additional Sec 5 & Alerts Annun. Sec 6 Symbols Figure 4-72 Sector Scan - Full 5) Turn the small MFD knob to select FULL, 60°, 40°, or 20° scan. Sec 7 Appendix A Glossary Sec 8 Index Appendix B Figure 4-73 Sector Scan - 40° 6) If desired, readjust the Bearing Line as discussed previously to change the center of the Sector Scan. 7) Remove Sector Scanning by returning the SECTOR SCAN value to FULL. 4-80 Garmin G500 Pilot's Guide 190-01102-02 Rev. B