HP BL25/35/45p HP ProLiant Network Adapter Software and Configuration Guide - Page 23
Probe_retry_count, Probe_send_interval, Probe_set_default, Probes, Recommit, Removeteam, Removevlanid
View all HP BL25/35/45p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
o Description: Changes probe retries check interval • PROBE_RETRY_COUNT o Syntax: probe_retry_count=nnn o Description: Changes probes retry count • PROBE_SEND_INTERVAL o Syntax: probe_send_interval=nnn o Description: Changes probes send interval, nnn counts 1/18 sec • PROBE_SET_DEFAULT o Syntax: probe_set_default o Description: Restores probes settings to factory settings • PROBES o Syntax: probes=[on | off] o Description: Enables/disables probes • PROBES o Syntax: probes=[BROADCAST|MULTICAST] o Description: Changes probes addressing • RECOMMIT o Syntax: recommit [team=nnn] o Description: Resets a certain mode. Use after hot binding to base drivers with Team=nnn • REMOVETEAM o Syntax: removeteam [team=nnn] o Description: Removes a team. Use after hot binding to base drivers with Team=nnn • REMOVEVLANID o Syntax: RemoveVlanID=nnn o Description: Removes the selected VLAN • RESET o Syntax: RESET LBN=nnn o Description: Supported only after Commit command • SECONDARY o Syntax: primary | secondary o Description: Identifies the secondary adapter. Supported only in BIND command. • SMPMODE o Syntax: SMPMODE=[SMP | NONSMP] o Description: Enables/disables SMP aware • STATUS o Syntax: status [team=nnn] o Description: Prints CPQANS status • TEAM Configuration and diagnostics 23