HP BL25/35/45p HP ProLiant Network Adapter Software and Configuration Guide - Page 70
A commonly used method to install a driver on a NetWare server is through NWCONFIG. The following
View all HP BL25/35/45p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
To enable the Gigabit Ethernet adapter to function correctly, you need to install the latest support pack files. The latest support pack can be found at the Novell website (http://www.novell.com). Netware install program A commonly used method to install a driver on a NetWare server is through NWCONFIG. The following drivers are supported. Driver configuration parameters Parameter CheckSum = Frame = type node = name = text Options Default = ON Selections are: ON, OFF, Tx, Rx Valid types are: Ethernet_802.2, Ethernet_802.3, Ethernet_II, Ethernet_SNAP NNNNNNNNNNNN Description Enables or disables the transmit and receive checksum off-loading feature. Checksum is supported under NetWare 5.x only. If you want to enable the CheckSum parameter, you need to load it on the first instance. Defines the frame type being used by this load instance. Ethernet_802.2 and Ethernet_II are the default values. Specifies a node address in this field to override the default Media Access Controller (MAC) address (also known as the Locally Administered Address) Displays the name assigned to this adapter PDriver = RxBuffers = TxDescriptors = RxFlow = TxFlow = Default = OFF Selections are: OFF, ON Allows driver to operate in persistent driver mode. Persistent driver mode is supported under NetWare 5.x only. Use only if adapter is placed in a Hot Plug PCI slot and only if required to swap with an exact board. Default = 200 Recommended Min = 32 Pre-allocates ECB resources on the adapter for receiving packets Max = 512 Min = 1 when used with DOS Client32 and when Keywrod P3-1 or 2. Default = 200 Recommended Min = 100 Pre-allocates ECB resources on the adapter for transmitting packets. Max = 512 Min = 1 when used with DOS Client32 and when Keywrod P3-1 or 2. Default = OFF Allows enabling/disabling of RxFlow control. Selections are: ON, OFF Default = OFF Allows enabling/disabling of TxFlow control. Selections are: ON, OFF Configuration and diagnostics 70