HP Cisco MDS 9120 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 204
Recommended Action, Error Message, Explanation, Introduced, vr abort
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 204 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] of sync. with this peer. We recommend that you discard this CFS session using ivr abort command and then re-enter the configuration changes. You can alternatively use Fabric Manager and/or Device Manager instead of the command line method. Recommended Action No action is required. Error Message IVR-2-DEVICE_FCID_REWRITE_FAILURE: Failure while programming FCID rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able to communicate with its peer devices. Explanation Device failed to program the FC ID rewrite entries; this probably occurred because the hardware ran out of FC ID rewrite entries. This can happen if there are too many devices in an inter-VSAN routing (IVR) zone, or there are too many local VSANs in the VSAN topology. Recommended Action Reduce the number of devices involved in inter-VSAN routing (IVR) in the active IVR zone set. Also, reduce the number of redundant transit VSANs, if any. Introduced Cisco MDS SAN-OS Release 2.1(1a). Error Message IVR-2-DEVICE_ON_WRONG_NATIVE_AFID_VSAN: Device with port WWN [chars] (FCID:[chars], native VSAN [dec] native AFID [dec]) may not be exported to other VSANs (for Inter-VSAN zoning) because it has come online in VSAN [dec] AFID [dec]. Explanation Device has come online on a different AFID/VSAN from the configured native AFID/VSAN, or the device does not satisfy unique domain criteria. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 2.1(1a). Error Message IVR-2-DEVICE_ON_WRONG_NATIVE_VSAN: Device with port WWN [chars] (FCID:[chars], native VSAN [dec]) may not be exported to other VSANs (for Inter-VSAN zoning) because domain [hex] exists in VSAN [dec]. Explanation Device has come online on a VSAN different from the configured native VSAN, or the device does not satisfy unique domain criteria. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message IVR-2-DEVICE_STATE_INCOMPATIBLE_WITH_NAT_MODE: State for device with port WWN [chars] could not be restored because it was incompatible with the current NAT mode([dec]). This probably happened because NAT mode was modified without completely deactivating the active IVR zoneset. Explanation This can happen if the Network Address Translation (NAT) mode is modified without completely deactivating the active inter-VSAN routing (IVR) zone set. Recommended Action Reboot the switch. Introduced Cisco MDS SAN-OS Release 2.1(1a). 2-168 Cisco MDS 9000 Family System Messages Reference OL-15956-01