HP Cisco MDS 9120 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 235

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message MODULE-2-MOD_REGFAILED: Registration failed for module [dec]. Explanation The module sent the registration message notifying a failure. Recommended Action Collect module information by entering the show module internal all module CLI command or by using a similar Fabric Manager procedure. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message MODULE-2-MOD_SOMEPORTS_FAILED: Module [dec] reported failure on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (error [hex]). Explanation Module reported a failure in the runtime diagnostic because of a failure in some of the ports. Recommended Action Collect module information by entering the show module internal all module CLI command or by using a similar Fabric Manager procedure. Introduced Cisco MDS SAN-OS Release 2.0(1b). Error Message MODULE-2-MOD_UNKNOWN: Module type [[dec]] in slot [dec] is not supported. Explanation The software card ID of module [dec] is not supported by the supervisor. Recommended Action Collect module information by entering the show module internal all module [dec] command or by using a similar Fabric Manager procedure. Update SPROM contents by entering the update sprom command or by using a similar Fabric Manager procedure. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message MODULE-2-XBAR_DIAG_FAIL: Xbar [dec] (serial: [chars]) reported failure on ports [dec]/[dec]-[dec]/[dec] ([chars]) due to [chars] in device [dec] (device error [hex]). Explanation The xbar in the slot reported a failure in the runtime diagnostic. Module manager is going to power cycle the module. Recommended Action Collect information about the module by issuing the show module internal all xbar CLI command or by using a similar Fabric Manager procedure.' Introduced Cisco MDS SAN-OS Release 3.0(1). Error Message MODULE-2-XBAR_FAIL: Initialization of xbar [dec] (serial: [chars]) failed. Explanation Xbar reported a failure during the initialization phase and will be powered down. Recommended Action Collect information about the module by issuing the show module internal all xbar CLI command or by using a similar Fabric Manager procedure. Introduced Cisco MDS SAN-OS Release 3.0(1). OL-15956-01 Cisco MDS 9000 Family System Messages Reference 2-199