HP Cisco MDS 9120 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 270
config terminal, interface, no shutdown, Check the attached device and replace it if needed.
View all HP Cisco MDS 9120 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 270 highlights
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message PORT-5-IF_BRINGUP_NOT_ALLOWED_PORT_CONFIG_FAILURE: Interface [chars] is not allowed to be operational due to port config failure for reason: [chars] ([hex]). Explanation Check interface configuration. Recommended Action Try to change the configuration on the interface with the current available hardware capability. Introduced Cisco MDS SAN-OS Release 3.0(1). Error Message PORT-5-IF_DOWN_ADMIN_DOWN: Interface [chars] is down (Administratively down). Explanation Interface has been configured to be administratively down. Recommended Action Enter the CLI commands config terminal, interface, no shutdown or use a similar Fabric Manager procedure to bring up the interface. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT-5-IF_DOWN_BIT_ERR_RT_THRES_EXCEEDED: Interface [chars] is down (Error disabled - bit error rate too high). Explanation The port has detected a bit error rate too high in frames received from attached device. Recommended Action Check the attached device and replace it if needed. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message PORT-5-IF_DOWN_BUNDLE_MISCFG: Interface [chars] is down (Isolation due to channel mis-configuration on local or remote switch). Explanation One port across a link is part of a PortChannel while the other is not. Recommended Action While adding or deleting a member port from a PortChannel, both ports across the link should be added or deleted. No operation should be performed on either port until they are both added or deleted. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message PORT-5-IF_DOWN_CFG_CHANGE: Interface [chars] is down(Config change). Explanation FCIP interface temporarily down because of reconfiguration. Recommended Action No action is required. Introduced Cisco MDS SAN-OS Release 1.2(2a). 2-234 Cisco MDS 9000 Family System Messages Reference OL-15956-01