HP Cisco MDS 9120 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 90

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message ETHPORT-5-IF_DOWN_ERROR_DISABLED: Interface [chars] is down (Error disabled). Explanation The interface encountered an error during configuration. Recommended Action Collect more information about failed interface using show port internal all interface [char]. In most cases, you can recover using a shutdown followed by a no shutdown Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message ETHPORT-5-IF_DOWN_ESC_FAILURE_ISOLATION: Interface [chars] is down (Isolation due to ESC failure). Explanation Exchange switch parameters (ESC) failed on the interface. Recommended Action Check the output of show port internal event-history to show the ESC protocol exchanges and determine how it failed. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message ETHPORT-5-IF_DOWN_ETH_IF_DOWN: Interface [chars] is down(Tunnel port src interface down). Explanation Ethernet link to which the FCIP interface is bound is down. Recommended Action Verify that the Ethernet cable is connected and that the interface is administratively enabled. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message ETHPORT-5-IF_DOWN_ETH_LINK_DOWN: Interface [chars] is down(Tunnel port src interface link down). Explanation Ethernet link to which the FCIP interface is bound is down. Recommended Action Verify that the Ethernet cable is connected and that the remote end is also active. Introduced Cisco MDS SAN-OS Release 1.2(2a). Error Message ETHPORT-5-IF_DOWN_FCOT_NOT_PRESENT: Interface [chars] is down (FCOT not present). Explanation The small form-factor pluggable (SFP) device has been removed. Recommended Action Insert an SFP. Introduced Cisco MDS SAN-OS Release 1.2(2a). 2-54 Cisco MDS 9000 Family System Messages Reference OL-15956-01