HP Cisco MDS 9120 Cisco MDS 9000 Family System Messages Reference (OL-15956-01 - Page 370

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family Send documentation comments to [email protected] Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_EC_ER_UNKNOWN_MESSAGE_TYPE ) Internal error - message type [chars]. Explanation Node was rebooted because of an internal logic error. Recommended Action 1. Ensure that the software is at the latest level on the cluster. 2. Ask your customer support representative for assistance. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_EC_ER_WAITPID_FAILED ) Internal error - waitpid failed [chars]. Explanation The process cannot launch the I/O program properly. Node was warm started because of this error. Recommended Action If this error is repeated continuously, follow these steps: 1. Reinstall the code on the node. The node will then have to be removed and added back to the cluster. 2. Ensure that the software is at the latest level on the cluster. If not, upgrade the cluster and if necessary repeat step 1 with the latest level of code. 3. Ask your customer support representative for assistance, if the error continues. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] Explanation The process cannot warm start the memory device. Node was rebooted because of this error. Recommended Action If this error is repeated continuously, follow these steps: 1. Reinstall the code on the node. The node will then have to be removed and added back to the cluster. 2. Ensure that the software is at the latest level on the cluster. If not, upgrade the cluster and if necessary repeat step 1 with the latest level of code. 3. Ask your customer support representative for assistance, if the error continues. Introduced Cisco MDS SAN-OS Release 1.3(1). Error Message SVC-4-NODE_WARNING_MSG: (SVC [dec]/[dec] SS_EID_FC_ER_MAPPING_STOPPED ) FlashCopy has been stopped [chars]. Explanation A flash copy mapping task stopped because of an error. A stopped flash copy may affect the status of other vdisks in the same I/O group. Preparing the stopped flash copies as soon as possible is advised. Recommended Action 1. Correct higher priority errors and then start the flash copy task again. 2. Mark the error you have just repaired as fixed. Introduced Cisco MDS SAN-OS Release 1.3(1). 2-334 Cisco MDS 9000 Family System Messages Reference OL-15956-01